Vulthraesk

Share:
by V. Sarela (Yautja)

Download disabled

The designer of this FontStruction has chosen not to make it available for download from this website by choosing an “All Rights Reserved" license.

Please respect their decision and desist from requesting license changes in the comments.

If you would like to use the FontStruction for a specific project, you may be able to contact the designer directly about obtaining a license.

Info: Created on 3rd February 2012 . Last edited on 6th January 2017.
License Creative Commons
Categories:
Sets:
Tags:
Fave Tags:
  • -

10 Comments

Excellent work. Very consistent design. I would try to put a cross stroke in the middle of Z. I very much like the m,M,w,W. 10/10
Comment by Frodo7 11th February 2012
Frodo7: Thanks! I tried that on Z, but I think it works better without. M/W were among the first characters I did, I like how they turned out (although now that I think of it, it would be more consistent/logical to have them like a "double N/U", but I think they give the font more character now.)
Comment by V. Sarela (Yautja) 11th February 2012
A font with character! 10/10
Comment by four 11th February 2012
An interesting and individual font that gets my 10/10

I think it could do with a little bit of adjustment to the letter spacing in places ... a bit of negative kerning to the F, f r and t. The T might benefit from moving it to the left a bit and then negatively kerning it to the same degree.
Comment by p2pnut 12th February 2012
Thanks for the comments!
p2pnut: The spacing is a bit of an issue since I didn't use filters, so the spacing can't be adjusted so precisely and some letters would overlap.
Comment by V. Sarela (Yautja) 12th February 2012
Congratulations! FontStruct Staff have deemed your FontStruction worthy of special mention. “Wulthraesk” is now a Top Pick.
Comment by Rob Meek (meek) 13th February 2012
Filters/no filters isn't a problem(I hardly ever use them myself).
What you need to do is play around with the (green) letter width guide to lose the unwanted gaps ... i.e. like the ones after the f or r. The j can overlap to the left - the tail is under the baseline.
I hope this image is a help
Comment by p2pnut 13th February 2012
The 'fine tuning' can be done using the Global Spacing (Preview/Menu/Spacing).

Hope this helps :)
Comment by p2pnut 13th February 2012
Thanks for the top pick!
p2pnut: Thanks, but the glyphs are in such a small scale (three bricks wide!) that it's no help. With 2x2 filters I could adjust "half a brick" which would make better spacing possible.

Edit: I updated this to 2x2 filters now.
Edit2: Updated again and added more characters.
Comment by V. Sarela (Yautja) 13th February 2012
Amazing. =)
Comment by Icelar 1st August 2013

Also of Interest

More from the Gallery

Timeriderby V. Sarela (Yautja)
Wolfenby V. Sarela (Yautja)
Scipheraby V. Sarela (Yautja)
Hi-NRGby V. Sarela (Yautja)
Badger Spineby hollydennis
STF_MR BOB DOUBALINAby Sed4tives
fs lostby ETHproductions
Hommage à Escherby Frodo7

From the Blog

News

New Bricks: Square Connectors

News

The Video Game Font Preservation Society

News

FontStruct goes open source!

News

New Bricks: Half Arcs